PDA

View Full Version : How to make a whistle out of a can.[Silly]



Strelok
01-14-2009, 06:56 PM
Excuse the picture quality, and find a can.
http://i41.tinypic.com/20igy1e.jpg

Cut the top and bottom of it off, lay the metal out flat. (Cut the sheet in half to make future cutting easier.)
http://i39.tinypic.com/hw9x5s.jpg

Cut a scrap of aluminum about 4/5ths of and inch by 2 inches. (Picture is 1" x 2", although that is WAY too thick, don't do it.
http://i39.tinypic.com/wwnb5w.jpg

Cut that in half length-wise and then cut one of those pieces in half Width-wise. You can remove one of the small pieces.
http://i39.tinypic.com/wj7vuu.jpg

Fold the long piece like a "P."
http://i42.tinypic.com/4rzsbs.jpg
http://i41.tinypic.com/2cyruao.jpg

Take the small part and fit it over the flat part, fold the edges down.
http://i43.tinypic.com/15oaxqa.jpg



To use, cover the sides with your finger and blow through the mouth-piece.

Phosphorus
01-14-2009, 07:57 PM
your skin is hella pale, imo.

Strelok
01-14-2009, 08:27 PM
your skin is hella pale, imo.

The flash made it look paler than it is. I'm still not the most tan person in the world, though.

2-D
01-14-2009, 08:30 PM
what does it sound like

Strelok
01-14-2009, 08:55 PM
what does it sound like

A whistle.

Depends how you make it.

Krob
01-14-2009, 08:57 PM
Coors light ftw.

Cosmonaut
01-14-2009, 09:42 PM
Awesome, I'm going to try this later.

Ampersand
01-15-2009, 07:06 PM
Coors light ftw.

It's a Bud Light.

Strelok
01-15-2009, 09:50 PM
Bood light.

elite34
01-15-2009, 10:02 PM
The quality is not that bad. But to get to the point this is actually a pretty interesting idea! I am gonna try it tommorow morning, providing I don't get distracted and forget.